Sprayer Info


Dilute sprayer chemical as required, mixing enough solution for your application (see dilution ratios). Twist tank counterclockwise 90 degrees to remove powerhead. Add liquid and replace powerhead, making sure tank gasket is in place.
CONNECT TO ELECTRIC SOURCE
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
If you need a longer power cord, we recommend a garden-type extension cord. Do not use one that is cut, frayed or otherwise damaged. To prevent accidental unplugging, knot the two cords, or use a cord retainer available at many hardware stores at a modest cost.
SPRAYER OPERATION
Slide the power switch to the "on" position. A fine mist will form. Adjust the control knob for the droplet sizes ranging from coarse droplets, which settle quickly, to fine spray particles which can float a long distance. The control knob also regulates the liquid flow rate. After setting the droplet size, you can calculate the liquid flow rate by timing how long it takes to dispense a measured amount of liquid.
If possible, apply your application in still air. Otherwise, your chemical may be blown off target. Use an even sweeping motion making certain to cover the entire target area. Do not over-apply. Since a fine mist is difficult to see, it is usually better to calculate spraying time and volume from the liquid flow rate than to rely on visible indications.
When finished spraying, remove and empty tank. Open the control knob and run the unit a few seconds to discharge any liquid remaining in the internal lines. If you have been spraying liquids containing solids or polymers, residue is likely to accumulate. Flush residues from internal lines by running unit with clean water (or the appropriate solvent) briefly.